Tight, clean, responsive bass.

The Temblor T10’s glass-composite low-frequency driver delivers tight and responsive bass, thanks to its lightweight and rigid cone. This design also provides lower distortion than other materials, ensuring that the sub-bass reproduction in your monitoring system is as coherent and clear as your full-range monitors.

A perfect fit with your full-range monitors.

Temblor-series subwoofers make integrating a subwoofer into your monitoring setup easy so you can create the flattest possible response. The Temblor T10 provides a continuously variable lowpass filter (50 Hz to 130 Hz), allowing you to create a seamless crossover transition between your full-range studio monitors and subwoofer for the most accurate listening environment possible.

The central hub of your monitoring setup.

Temblor T10 subwoofers provide the connections and controls necessary to act as the central hub for a basic monitoring setup. A switchable highpass filter on the full-range outputs helps to avoid frequency cancellation and reinforcement in the subwoofer’s upper range. A polarity invert ensures your system is in phase.

The Temblor T10 also features a momentary footswitch (included), making it easy to compare your mix with or without sub-bass frequencies and ensure it will sound good on a wide variety of systems.

Accuracy defined.

When you hear the low-frequency foundation of your mix accurately, you can make more informed decisions and create more translatable mixes. Temblor T10 subwoofers are the natural sub-bass extension for virtually any full-range monitoring system.

Features

Main components

10-inch, front-firing, glass-composite low-frequency transducer

Front-firing, bass-reflex acoustic port

Controls and filters

Input gain control (-30 dB to +6 dB, continuously variable)

Continuously variable lowpass filter (50 Hz to 130 Hz)

Built-in crossover

Switchable highpass filter removes frequency content below 80 Hz from the full-range signal sent from the Temblor outputs to the main monitors

Momentary footswitch (included) bypasses the subwoofer, highpass filter, and Sub Out

Polarity invert

Ground-lift switch

Power and safety

250 watt, Class AB amplification

Internal damping and heat sink

Integrated rubber feet for stable placement

Inputs and outputs

Left and right, balanced XLR and ¼” TRS and unbalanced RCA main inputs

Left and right balanced XLR and ¼” TRS outputs 

XLR subwoofer output for connecting a second Temblor® T10